Skip to content

Clip Envelope Actions

The following Actions are all Track-based Actions that allow you to manipulate the Envelopes of a Clip in various ways. These Actions can be applied to Clips in the same way as Clip Actions.

CLIP ENVCLR

Clear all parameter Envelopes from the Clip.

CLIP ENVCLR x

x is the parameter associated with the Envelope to clear from the Clip.

CLIP ENVCLR VOL
CLIP ENVCLR DEV B1 P6

CLIP ENVCLRD DEV(x)

x is the Device(s) whose parameter Envelopes should be cleared from the Clip. You can specify Devices as covered in Device Actions.

CLIP ENVCLRD DEV(SEL)
CLIP ENVCLRD DEV(2-4)

CLIP ENVHIDE

Hide the Clip's Envelope view. This actually applies to all Clips.

CLIP ENVINS x

x is the parameter to insert a single point Envelope for in the Clip. This will first clear the parameter's Envelope if one exists.

CLIP ENVINS VOL
CLIP ENVINS SEL

CLIP ENVSHOW

Show the Clip's Envelope view. This actually applies to all Clips.

CLIP ENVSHOW x

x is the parameter associated with the Envelope to show in Envelope view.

CLIP ENVSHOW VOL
CLIP ENVSHOW DEV B1 P6
CLIP ENVSHOW SEL

Specifying parameters

To specify the parameter to insert an Envelope for, you can use the following:

  • VOL – Track Volume
  • PAN – Track Pan
  • PANL – Track Left Split Stereo Pan
  • PANR – Track Right Split Stereo Pan
  • MUTE – Track Mute
  • SEND ltr – Track Send where ltr is the letter of the Send (such as SEND C)
  • SEL – The last parameter on the Track that was clicked on with your mouse.
  • BOUND – For use with the optional ClyphX Pro Bindings Accessory. The last parameter that was adjusted via the Bindings Accessory.

You can also insert an Envelope for the parameter of a Device. You'll specify the Device containing the parameter as covered in Device Actions (DEV(1) for example). Then, to specify the parameter to insert an Envelope for, you'll specify the parameter's name or DEV Bn Pp (DEV B2 P8 for example) or DEV Pp (DEV P5 for example), all of which work in the same way as they do in Device Actions.